Sensor Calibration - Toshiba DB-EA4D SERIES Owner's Manual

5. PRINTER SETUP

5.7 SENSOR CALIBRATION

Be careful when handling the print head as it becomes very hot.
Be careful not to trap and injured your finger when opening or closing the Top Cover.
Soyez prudent lorsque vous manipulez la tête d'impression puisqu'elle devient chaude.
Soyez prudent de ne pas coincer vos doigts pendant que vous ouvrez ou fermez le boîtier de
dessus.
It is necessary to perform sensor calibration prior to paper loading if using an non-specified paper by
TOSHIBA TEC, by following the below procedure:
2ST printer supports 4 categories of sensor calibration functions. Refer to the following table.
Function
Calibration with BM Paper
Calibration with White Paper
Calibration with Label Paper
Calibration with Perforation
Paper
NOTE:
If PE sensor detects paper end during this mode, paper will be ejected. This adjusted value is
used for Cut Sheet Mode as well.
WARNING!
AVERTISSEMENT!
It performs sensor calibration with black mark paper.
It performs sensor calibration without black mark
paper and label paper.
It performs sensor calibration with label paper.
It performs sensor calibration with Perforation paper.
E5-12
Description
ENGLISH VERSION
5.7 Sensor Calibration