Toshiba DB-EA4D SERIES Owner's Manual page 61

5. PRINTER SETUP
The following settings of Menu Mode are valid in H print test.
Paper Type, Form Length, Paper Width, Paper Density, Power Control, Maximum Speed, Page
Recovery (only Online mode), BM Cut Offset, Label Cut Offset, Top Margin, Label Top Margin,
BM Cut Position and Label Cut Pos, Paper Load.
3. Dot check pattern print test
This mode performs rolling Dot check pattern print test repeat, and page number is printed on the top
left corner of the page.
The print result as follows.
Page number
12.5% slant line pattern
If the setting of paper type is Black Mark Mode, the paper is cut at the next Black Mark (w/ Cutter) or
fed to the next Black Mark to cut at manual cut position (w/o Cutter). If the paper type is Document
Length Mode, the paper is cut at the end of the page (w/ Cutter) or fed to the end of the page to cut at
manual cut position (w/o Cutter). If the paper type is Label Mode, the paper is cut at the next gap (w/
Cutter) or fed to the next gap to cut at manual cut position (w/o Cutter).
The following settings of Menu Mode are valid in Dot check pattern print test.
Paper Type, Form Length, Paper Width, Paper Density, Power Control, Maximum Speed, Page
Recovery (only Online mode), BM Cut Offset, Label Cut Offset, Top Margin, Label Top Margin,
BM Cut Position and Label Cut Pos, Paper Load.
00000001
Depends on a paper width
(Paper Width function setting in Menu Mode.)
E5-33
ENGLISH VERSION
5.9 Parameter Setting In Menu Mode
Depends on
Document Length or
Label Length Setting