4. BASIC FUNCTIONS OF OPERATION PANEL
4.3.3 Menu Mode
Power ON
Power OFF
Press and hold [MENU] key
+
turn the printer on
Sequence:
1. There are two different ways to enter Menu Mode.
a) When the printer is powered off,
press and hold [MENU] key
and turn the printer on.
b) When the printer is on and in READY
or PAUSE state,
press and hold [MENU] Key for three seconds.
2. All I/F are in BUSY state during this mode.
And a message appears on the LCD, as shown below.
Menu Mode
Press FEED Key
3. During the above message is displayed,
a) Press [FEED] Key shortly, it enters the Menu Mode.
b) Press [MENU] Key shortly, it exits this mode and shifts to READY state.
c) Press [FEED] Key long (around 3 seconds), it exits this mode and shifts to READY state.
Key function in Menu Mode
Key
[MENU]
[PAUSE]
[FEED]
NOTE:
Please refer to Appendix II for Menu Mode Tree of this 2ST Printer.
READY
Press and hold [MENU] key for 3 sec
Menu Mode
Fuction
Shift the next menu downward
Increase a value
Shift the next menu upward
Decrease a value
Enter menu
Save the setting
Firmware Version, CRC
Communication Interface
Printer Configuration
Printer Adjustment
Printer Test Modes
Sensor Calibration
Menu Mode Exit
E4-7
ENGLISH VERSION
4.3 Special Functions