Connecting Sources - Christie DW30 User Manual

Section 2: Installation and Setup
2.3 Connecting
Sources
RGB signals (5 BNCs)
2-12 Christie DS+60/DW30/Matrix 3000 User's Manual
Sources connect to the Input Panel located at the back of the projector. See Figure
2.10.
The upper right corner (
analog RGB source, or it can also be used for YPbPr signals or additional video
sources. The DVI-I connector at
a computer. Connect analog composite video at
devices such as VCRs, laser disk players or DVD players.
Christie offers optional input modules that can be installed into the projector at
to connect other sources.
5
NOTES: 1) See Section 6, Specifications for details regarding compatible inputs. 2)
Use only high quality shielded cables only for all connections.
'
consists of 5 BNCs (connectors) for linking to a variety of sources. The
INPUT 1
typical connection would be to an RGB source such as a PC, Mac, Sun, SGI and
others. This projector supports multiple sync types with RGB signals: sync-on-green,
composite sync, and separate H & V syncs.
Connect the BNC input(s) first. Then connect the red, green and blue source
SYNC
outputs to the ,
RED GREEN
sync-on-green, only the red, green, and blue connections are required. If the source
provides a composite sync output, connect it to the
the source provides separate horizontal and vertical sync outputs, connect horizontal
sync to the input labeled
SYNC
labeled See Figure 2.11.
VERT.
NOTE: Depending on your source, you may need a custom adapter cable with BNC
connectors at the projector end and a different type of connector at the other (such as
a 15-pin "D" connector for some computer sources). Contact your dealer for details.
) typically accepts an RGB signal from an external
INPUT 1
accepts digital or analog display signals from
INPUT 2
INPUT 3
Figure 2.10. Input Panel
, and BNCs on the
BLUE
and connect vertical sync to
HOR/COMP
or S-video at
INPUT 4
panel. If the source uses
INPUT 1
input labeled
SYNC HOR/COMP
SYNC
from
INPUT
. If
input