Table of Contents
Advertisement
Section 2: Installation and Setup
Step 4
Step 5
Step 6
Step 7
2-2 Christie DS+60/DW30/Matrix 3000 User's Manual
'
Connect the Line Cord
North American and European rated line cords are provided with each projector.
Make sure you use the correct line cord for your area.
Connect the appropriately rated line cord (supplied with the projector) to the AC
receptacle located on the lower right side of the projector and the other end to an AC
outlet (100-240V). Do not use a line cord or AC supply not in the specified voltage
and power range. See Section 6 – Specifications for projector power requirements.
'
Turn the Projector ON
Press
for two seconds to turn the projector on. As the projector begins
initialization an active pattern of segments appear in the two-digit display located on
the built-in keypad. Wait for "ON" to appear in the display before sending any keypad
commands otherwise the command will be ignored.
By default, the projector powers up in dual lamp mode. Refer to Section 3 – The Lamp
Menu for more information on lamp operation modes and lamp auto-switching.
'
Select a Source
Press one of the input keys (remote or built-in keypad) to select and display the image
from that source.
'
Perform Auto Setup on the current source
Auto
Press
to automatically initiate the optimization of critical display parameters for
the selected source, which includes but is not limited to size, position and pixel
tracking. After this process is complete, additional modifications can be made to
image settings as required.
Advertisement
Table of Contents
