Table of Contents
Advertisement
Section 4: Maintenance
Projector Location
Lamps
Power Cord
and Attachments
4-2 Christie DS+60/DW30/Matrix 3000 User's Manual
'
Operate the projector in an environment, which meets the operating range as specified
in Section 6 – Specifications.
◊
Do not operate the projector close to water, such as near a swimming pool. Do not
operate in extremely humid environments.
◊
Do not place the projector on an unstable cart, stand or table. A projector and cart
combination should be used with care. Sudden stops, excessive force and uneven
surfaces may cause the projector and cart combination to overturn.
◊
If the projector is to be ceiling mounted, use only the Christie-approved ceiling
mount fixture.
'
The two 300W P-VIP lamps in the projector require replacement when they have
reached their end of life (approximately 1500 hours), if they have failed during
operation, or have a drastic change in brightness (typical of aging lamps). To
effectively maintain operation of the projector it is best to be aware of any changes
that occur in brightness and the number of hours each lamp is in use. Refer to 4.4.
Lamp Replacement for more details on lamp replacement.
NOTE: These are mercury-containing lamps. Handle appropriately. Refer to
Appendix G for the lamp product safety data sheet.
Follow all safety and warning precautions regarding lamp replacement and handling.
Wait approximately 5 minutes to allow the lamp to cool
Do not stick hands into the lamp compartment during
The lamp is under great pressure when hot and may
explode causing physical injury and/or property
damage. Allow a lamp to cool before handling and/or
Use only the lamps supplied by CHRISTIE, in the Lamp
'
Use only the attachments and/or accessories recommended by CHRISTIE. Use of
others may result in the risk of fire, shock or personal injury.
Use only the AC power cord supplied. Do not attempt
operation if the AC supply is not within the specified
◊
Do not set or rest items on the power cord. Place the projector in an area where
the projector cord cannot be abused or damaged by persons walking on it or by
objects rolling over it.
◊
Operate the projector at the specified voltage only. Do not overload power outlets
and extension cords as this can result in fire or shock hazards.
WARNING
before removing.
lamp replacement.
powering down and unplugging the projector.
Replacement Kit.
WARNING
voltage and power range. See Section 6.
Advertisement
Table of Contents
