Table of Contents
Advertisement
Section 3: Operation
Figure 3.17. Using the "Network Routing" Option
Messages originating from an RS232 or RS422 controller
RS232 AND RS422 JOINED:
will be relayed to all RS232or RS422 ports. Any Ethernet communication, however,
will not.
Messages to and from the RS232 ports will also be
RS232 AND ETHERNET JOINED:
relayed to the Ethernet port, and vice versa. Any RS422 communications will be
isolated.
All messages reach all ports, regardless of type.
ALL JOINED:
Ethernet Settings –
SUBMENU
NOTES: 1) Recommended for network administrators only.
Enable this checkbox if you want a DHCP server to automatically change the
DHCP:
projector's default IP address (0.0.0.0) to one that is valid and unique for use on the
current Ethernet network. On networks without a DHCP server, or to simply override
the automatic DHCP server function, delete the checkmark and enter the new "IP
Address" settings desired. Remember that only a 0.0.0.0 address will trigger the
DHCP addressing service, and only when the DHCP checkbox is enabled.
Enter a valid and unique IP address for use on the network to which the
IP ADDRESS:
projector is currently connected. This address will overwrite any previous IP address
such as the projector's factory-defined default (0.0.0.0), or one that has been assigned
by a DHCP server or other user. It takes approximately 10 seconds for the projector to
respond at its new address.
On some Ethernet networks, firewall restrictions may require that the port
PORT:
number of the projector be changed from its default of 3002. If so, enter a new valid
port number here.
Christie DS+60/DW30/Matrix 3000 User's Manual
3-37
Advertisement
Table of Contents
