Table of Contents
Advertisement
Section 3: Operation
Use this
COLOR SATURATION:
submenu if you do not have
specific color coordinates in mind
and will simply judge color
performance by eye or meter. Like
the Color Adjustment by X,Y
submenu, each color control
actually defines new x/y
coordinates for that color and
changes its hue—it is just a
different interface.
Adjust the hue of each primary
color (red, green, blue, and white)
by using more or less of it in
Figure 3.22. Customize Color
relation to the other colors.
NOTE: A Color Saturation adjustment defines the corresponding x/y coordinates
shown in the Color Adjustment by X,Y submenu. These x/y coordinates will remain
stable for this User gamut until they are changed again via either menu. Values
displayed in the Color Saturation menu, however, will likely fluctuate as you use the
projector, and will be different when you return to this menu at some point in the
future. These floating changes do not affect the x/y coordinates or gamut.
'
System Configuration
Test Pattern
DIAGNOSTICS / CALIBRATION
Choose the desired internal test
pattern to display, or select OFF
to turn off a test pattern.
Alternatively, use the
key
Test
for cycling through test patterns.
NOTE: There is a center line
(both horizontal and vertical) in
the Edge Blending test pattern.
The intersection of these lines is
the true center of the projector's
display area.
Test Pattern Grey Level
Set the desired level of grey for displaying in the full gray field test pattern.
Freeze Image
Enter a check mark to freeze (stop) an image on a single frame. This diagnostic tool is
useful if you need to examine in detail a still version of an incoming image that cannot
be "frozen" at the source. For example, in moving images it is sometimes difficult to
observe artifacts such as external deinterlacing/resizing and signal noise. Remove the
checkmark to return back to normal.
Color Enable
Select which color or colors you want to see. This is useful while working with color
temperature, input levels or other special setup parameters. Colors can also be
Christie DS+60/DW30/Matrix 3000 User's Manual
3-43
Advertisement
Table of Contents
