Table of Contents
Advertisement
Section 2: Installation and Setup
Figure 2.11. Connecting RGB and Sync
NOTES: 1) If for some reason the projector fails to recognize a signal as an RGB
signal, specify the Color Space option within the Image Settings menu. See 3.7,
Adjusting the Image. 2) To connect YPbPr signals–such as from DVDs or analog HDTV
INPUT 1
sources–to
, use the red, green and blue BNCs as described in YPbPr Signals
(below). 3) Use the computer cable provided, to connect some devices to the DVI-I
connector at Input 2.
'
YPbPr signals
Connect a YPbPr signal (component video) to
or
as shown in Figure
INPUT 1
INPUT 2
2.12.
NOTES: 1) If, for some reason, the projector fails to recognize a YPbPr signal,
specify the Color Space option within the Image Settings menu. See 3.7, Adjusting
the Image. 2) Do not connect digital component signals (known as YCbCr) to
INPUT
INPUT 5
. Install an appropriate optional module in
for this.
1
Figure 2.12. Connecting YPbPr sources
Christie DS+60/DW30/Matrix 3000 User's Manual
2-13
Advertisement
Table of Contents
