Table of Contents
Advertisement
Section 3: Operation
'
Working with PIP
NOTE: To control the primary image, access all picture controls through the Main
menu. To control the secondary (PIP) image, access picture controls through the
Picture-in-Picture and Switching menu.
Use the first of six
options in the PIP
and Switching menu
to enable and define
how you want to use
PIP.
Swap Main and PIP Image
Toggle the current picture-in-picture relationship so that the primary (main) image
becomes secondary (PIP), and the secondary image becomes primary. Swapping is
available only when PIP is enabled.
NOTE: There may be a slight delay when swapping the Primary and Secondary
images.
PIP Enable
Short cut: Press
on the
remote.
Toggle to display from two
sources at once (Picture-in-
Picture) or the primary source
only. This checkbox turns the
secondary source on and off.
NOTE: Disable PIP and Best Switching for Interlaced sources > 35kHz.
PIP Size and Position –
SUBMENU
Most controls in the PIP Size and
Position menu adjust the PIP
(secondary) image in the same
fashion as their counterparts in the
main Size and Position menu
adjust the main image—see 3.5,
Adjusting the Image for details.
Exceptions are:
–Set the
POSITION PRESETS
location of the PIP (secondary)
image in the display.
– Choose the desired aspect ratio for your PIP pixels. Use
ASPECT RATIO PRESETS
the "Default" aspect ratio when incoming format has square pixels (most common).
This ensures that the resulting PIP image maintains its intended aspect ratio. Use
Christie DS+60/DW30/Matrix 3000 User's Manual
3-47
Advertisement
Table of Contents
