Loading Sheet Media - HP C2858A Service Manual

LOADING SHEET MEDIA

To load sheet media, perform the following steps:
1. Ensure that the pinchwheel lever is down and the roll cover is closed.
2. Load the leading edge of the sheet making sure to push the sheet in straight (not
skewed) while aligning the right edge of the sheet with the perforated line on the
entry platen. See Figure 3-8.
(C) C2847-15a(UM)
3. Push the sheet in until it buckles slightly as it hits the stops inside the plotter. (The
buckling should be even across the width of the sheet.) Let go as soon as the plotter
begins to pull the media in.
4. When the front panel displays "Sheet load/Roll load," press the Up Arrow button to
select "Sheet load."
5. When the front panel displays "SELECT MEDIA," press the Up or Down Arrow
button to scroll through and select the media choice. Press the Enter button to set the
plotter for the media type being used. The plotter will now load the sheet of media.
6. The plotter moves the sheet in and out to check its size and alignment, then advances
it to the start of the page. When sheet loading is complete, the "STATUS Ready to
plot" message is displayed.
Download Free Service Manual and Resetter Printer at http://printer1.blogspot.com

Loading Sheet Media

Figure 3 8.
Installation and Configuration
Insert Media Until
it Buckles Evenly
Align Media with
Perforation Line
3-11