Front Panel Removal - HP C2858A Service Manual

FRONT PANEL ASSEMBLY REMOVAL
To remove the front panel assembly, perform the following procedure:
1. Remove the right endcover.
2. Disconnect the window sensor connector and the front panel cable connector from
the front panel assembly. See Figure 6-17.
3. Release the front panel cable from the clamp on the front panel assembly.
4. Using a TORX T-20 screwdriver, loosen the three screws that connect the front panel
assembly to the right sideplate and slide the front panel assembly clear of the plotter.
Window Sensor Connector
Front Panel Cable
Connector
Removal and Replacement
6-24
Download Free Service Manual and Resetter Printer at http://printer1.blogspot.com
(C)C2858-49b
Figure 6-17.
Screws (3)