HP C2858A Service Manual page 143

Test
Cutter
Button Test
X-motion
Control
Bail Cycle Test
Line Detect
Sensor
Troubleshooting
8-18
Download Free Service Manual and Resetter Printer at http://printer1.blogspot.com
Table 8-3. Service Tests (Continued)
Description
Verifies operation of the cutter. Allows either
single or continuous cut operation. An offset
value can be entered to determine how much
margin the cutter system has.
The display indicates which button the servo
processor interprets as being pressed. Button
code is matched against a look-up table.
Three failure modes are possible:
1) Button indicated on display is incorrect.
2) Display does not change when button is
pressed.
3) "Button Fail" shown on display if no code
match was found.
EXIT by pressing UP ARROW and DOWN
ARROW at the same time.
The X-axis motor is continuously driven
forward in swath-advance increments.
Pressing the UP ARROW increases speed.
Pressing the DOWN ARROW decreases
speed. EXIT by pressing the ENTER button.
Continuously raises and lowers the bail.
Tests and verifies operation of color detection
capability. Also checks line detect LED.
Assemblies
Tested
Cutter Assembly
Pen Carriage/
Cutter Assembly
Operation
Rotary Blade
Overdrive
Support
Assembly
Front Panel
Front Panel
Cable
Main PCA
X-Motor/
Encoder
Interconnect
PCA
Main PCA
Overdrive Drive
Roller
Drop Sensor
Drop Sense
Cable
Bail Sensor Flag
Bail; Drive
Mechanics
Main PCA
Line Detect LED
Pens