HP C2858A Service Manual page 44

Message
#
Pull / Align
edges to roll
Remove media
Continue
Replace
Y, C, M, K pen
Reseat
Y, C, M, K pen
Sheet load
Roll load
Sheet / Roll?
Reload media
Download Free Service Manual and Resetter Printer at http://printer1.blogspot.com
Table 3 3. Action Messages (Continued)
Action
$
Grasp the left and right free edges of the roll media and pull toward
you until the media is taut. At the same time, align the left and right
edges of the media so that they are flush with the left and right edges of
the roll.
Ink is dry; you can remove the accuracy calibration plot the plotter just
!
produced. Press Down Arrow to continue with accuracy calibration.
Y, C, M, or K pen has a clogged nozzle. You must replace the defective
pen to continue. Defective pen position is indicated by a flashing icon
in the display.
Y, C, M, or K pen has not made proper contact in the pen slot. Remove
the appropriate pen and reseat it in the slot. Defective pen position is
indicated by a flashing icon in the display.
!
Press Up Arrow to load sheet media.
!
Press Down Arrow to load roll media.
You have chosen Sheet mode while loading roll media. Reload media.
You have loaded a sheet more than 51 inches (130 cm) long. Trim
sheet and reload.
Installation and Configuration
3-25