Unloading Roll Media - HP C2858A Service Manual

the media so that they are flush with the left and right edges of the roll. See
Figure 3-7.
(C) C2847-97(UM)
14. When the front panel instructs you, lower the pinchwheel lever. The plotter checks
to make sure the roll is properly aligned.
15. When "Close roll cover/Continue
any slack in the roll. Make sure the leading edge of the media is outside the roll cov-
er, then close the roll cover. Press the Down Arrow button to continue. The plotter
trims off the first few inches of media. When roll loading is complete, the "STATUS
Ready to plot" message is displayed.

UNLOADING ROLL MEDIA

To unload roll media from the platen without removing the spindle from the plotter, do the
following steps:
1. Raise the pinchwheel lever to the up position.
2. Open the roll cover and turn the media stop to wind the media back onto the spindle.
3. Close the roll cover.
4. Lower the pinchwheel lever to the down position.
To remove the spindle with roll media, perform steps 1 and 2 above, then pull on both ends of
the spindle to remove it from the plotter.
Installation and Configuration
3-10
Download Free Service Manual and Resetter Printer at http://printer1.blogspot.com
Aligning the Left and Right Edges of the Media
Figure 3-7.
!
" is displayed, rewind the media stop to take up
(C) C2847-97a(UM)