HP C2858A Service Manual page 43

Drafting plotters
Hide thumbs Also See for C2858A:
Table of Contents

Advertisement

Message
Special Media
Mono Media
Calibrate done
Continue
Can't replot
Resend plot
Close roll cover
Continue
Create plot
Measure plot
Lift lever
Load arrow edge
print side down
Load cancelled
Remove media
Load media
to align pens
Lower lever
after aligning
Lower window
to continue
Open window to
access pens
Pen alignment
Close window
Power OFF
Check Pen Path
Power OFF
Check Paper Path
Installation and Configuration
3-24
Download Free Service Manual and Resetter Printer at http://printer1.blogspot.com
Table 3 3. Action Messages
Action
Press Up Arrow for Color plotting on Special (CX) paper.
Press Down Arrow for Monochrome plotting.
Accuracy calibration is complete. Press Down Arrow to continue.
!
Replot buffer doesn't have enough memory to hold the entire plot. Re-
send the plot.
Rewind the media to take up any slack in the roll, close the roll cover,
!
then press Down Arrow to continue.
!
Press Up Arrow to create a calibration plot.
!
Press Down Arrow to measure a calibration plot.
Lift the media lever at the right of the plotter.
Remove accuracy calibration plot, turn it so that the edge with arrows
printed on it is print side down, then load that edge into the plotter.
You pressed the Cancel button while media loading was in progress.
Remove media.
Load media to proceed with pen alignment.
When you've finished aligning the roll media as instructed, lower the
media lever at the right of the plotter.
You have lifted the window while the processor is busy. Close the win-
dow to continue.
Lift the window to access the pens.
Close the window to proceed with pen alignment.
Y-Axis servo shutdown. Troubleshoot and repair.
X-Axis servo shutdown. Troubleshoot and repair.

Advertisement

Table of Contents
loading

This manual is also suitable for:

C2859a

Table of Contents