HP C2858A Service Manual page 134

Drafting plotters
Hide thumbs Also See for C2858A:
Table of Contents

Advertisement

Error Code
010041
010050
010051
010052
010080
020001
020002
030000
030001
030002
030003
030010
04xxxx
Download Free Service Manual and Resetter Printer at http://printer1.blogspot.com
Table 8-2. System Error Codes (Continued)
Problem Description
Error detected in Y-axis servo
feedback loop.
Uppermost SIMM indicates a
failure.
Next to uppermost SIMM
indicates a failure.
Both upper and lower SIMMs
indicate a failure.
RS-232-C data overflow.
Firmware problem. Bad
EPROMS.
X-axis shutdown.
Y-axis shutdown.
Y-axis friction too high.
Y-axis failure
Excess friction in pen
capping assembly
MIO interface error.
Corrective Actions
Check encoder strip, carriage assem-
bly, trailing cable, main PCA.
Replace uppermost SIMM.
Replace next to uppermost SIMM.
Replace both upper and lower SIMMs.
Data byte was not read before another
was entered into the UART. Replace
main PCA. If problem remains report
the firmware problem to the HP
Response Center or the nearest HP
Sales and Support Office.
For all 2XXXX errors, report the
firmware problem to the HP Response
Center or the nearest HP Sales and
Support Office. Note conditions
before the error occurred. Include
system configuration in the report.
All 300XX errors indicate a failure of
hardware or electronics of the X- or
Y-Axis. Refer to SERVO CONTROL
SYSTEM FAILURES in this chapter.
Refer to code 030000.
Check mechanical parts in pen cap-
ping assembly for binding.
If an MIO is installed, check the MIO
setup. Then replace the MIO.
Troubleshooting
8-9

Advertisement

Table of Contents
loading

This manual is also suitable for:

C2859a

Table of Contents