Bail Assembly Removal - HP C2858A Service Manual

Drafting plotters
Hide thumbs Also See for C2858A:
Table of Contents

Advertisement

BAIL ASSEMBLY REMOVAL

To remove the bail assembly, perform the following procedure:
1. Raise the window and move the pen carriage assembly to the extreme left.
2. Slide the cutter assembly to the extreme right.
3. Using a TORX T-15 screwdriver, remove the three screws at the left and right ends of
the bail that attach the bail to the left and right bail brackets. See Figure 6-29.
4. Lift the bail up and clear of the plotter.
(C)C2858-11
Download Free Service Manual and Resetter Printer at http://printer1.blogspot.com
Bail
Screws (3
Each End)
Figure 6-29.
Removal and Replacement
(C)C2858-11
6-43

Advertisement

Table of Contents
loading

This manual is also suitable for:

C2859a

Table of Contents