Outer Electronics Enclosure Assembly Removal (C2858A Only) - HP C2858A Service Manual

Drafting plotters
Hide thumbs Also See for C2858A:
Table of Contents

Advertisement

OUTER ELECTRONICS ENCLOSURE ASSEMBLY REMOVAL
(C2858A ONLY)
To remove the outer electronics enclosure assembly, perform the following procedure:
1. Remove the electronics enclosure cover.
2. Disconnect all the cables from the PCAs shown in Figure 6-6.
3. Using a Torx T-15 screwdriver, remove the bottom three, and loosen the top three,
electronics enclosure assembly screws shown in Figure 6-6.
4. Carefully lift up and pull the electronics enclosure assembly from the plotter making
sure to ease the cables through the slots in the assembly.
(L)C2858-32c
Download Free Service Manual and Resetter Printer at http://printer1.blogspot.com
Loosen Screws
(Screw accessed
through hole)
Remove screws
Figure 6-6.
Removal and Replacement
6-11

Advertisement

Table of Contents
loading

This manual is also suitable for:

C2859a

Table of Contents