MEDIA DIVERTER REMOVAL
To remove the media diverters, perform the following procedure:
1. Remove the window assembly.
2. Remove the left and right endcovers.
3. Remove the encoder strip.
4. Remove the bail assembly.
5. Remove the overdrive support assembly.
6. Remove the drive roller assembly.
The media diverters are made of a clear plastic. Observe that the long
tab on each of the media diverters is oriented vertically and toward the
left side of the plotter before performing the next step.
7. Flex each media diverter and pull it free of the chassis assembly. See Figure 6-36.
(C)C2858-29a
Removal and Replacement
6-56
Download Free Service Manual and Resetter Printer at http://printer1.blogspot.com
Note
Media Director
Media Diverters
Figure 6-36.