Loading The Plotting Medium - HP 7475a Operation And Interconnection Manual

NOTCH
PEN·HOLDING
JAWS

Loading the Plotting Medium

The plotter is designed to be used with HP paper and pens. Use of other
paper may cause poor line quality. For best results, order papers listed
under Accessories Available. To load paper, proceed as follows:
1 .
Set the
US/MET
riate positions shown below that correspond with the paper size
being used.
Combination
Switch Settings
NOTE:
The positions of the
by the plotter only when power is first turned on, or when a front­
panel reset is invoked using the
power is turned on, paper size can be toggled between A and B or
A4 and A3 sizes using the front-panel
2. Check that the right pinch wheel is properly positioned for the
paper being used. Refer to the following illustrations.
PLOITER OPERATION
2-26
PEN
-
Loading the Pens and the Carousel
and switches o n the rear panel to the approp­
A4/A3
US/M
US/A3
MET/A4
MET/A3
US/MET
SPINDLE
Selected Default
Paper Size
ANSI A
ANSI B
ISO A4
ISO A3
and switches are checked
M/A3
+ VIEW
push buttons. After
ENTER
+
pushbuttons
ENTER SIZE
. •