INTERCONNECT PCA REMOVAL
To remove the interconnect PCA, refer to Figure 6-4 and perform the following steps:
1. Remove the electronic enclosure cover.
The cable connectors disconnected in the next step are labeled "P" for paper
axis and "C" for carriage axis. Note the orientation of the cable connectors
for assembly.
2. Disconnect the paper axis and carriage axis connectors from the interconnect PCA.
3. Using a TORX T-10 screwdriver, remove the two screws that secure the interconnect
PCA to the electronics enclosure assembly.
4. Gently pull the interconnect PCA clear of its main PCA connection and lift the PCA
clear of the plotter.
Locating Pin
(C)C2858-46
Paper Axis Connector
Carriage Axis Connector
When installing the Interconnect PCA, ensure the locating hole in the upper
left corner of the PCA engages the locating pin on the electronics enclosure.
Removal and Replacement
6-8
Download Free Service Manual and Resetter Printer at http://printer1.blogspot.com
Note
Screw
Figure 6-4.
Note
Screw
Main PCA Connector