Loading Sheet Media - HP 650C User Manual

Drafting plotters service manual
Table of Contents

Advertisement

LOADING SHEET MEDIA

To load sheet media, perform the following steps:
1. Ensure that the pinchwheel lever is down and the roll cover is closed.
2. Load the leading edge of the sheet making sure to push the sheet in straight (not
skewed) while aligning the right edge of the sheet with the perforated line on the
entry platen. See Figure 3-8.
(C) C2847-15a(UM)
3. Push the sheet in until it buckles slightly as it hits the stops inside the plotter. (The
buckling should be even across the width of the sheet.) Let go as soon as the plotter
begins to pull the media in.
4. When the front panel displays ªSheet load/Roll load,º press the
select ªSheet load.º
5. When the front panel displays ªSELECT MEDIA,º press the
button to scroll through and select the media choice. Press the
plotter for the media type being used. The plotter will now load the sheet of media.
6. The plotter moves the sheet in and out to check its size and alignment, then advances
it to the start of the page. When sheet loading is complete, the ªSTATUS Ready to
plotº message is displayed.
Insert Media Until
it Buckles Evenly
Align Media with
Perforation Line
Up Arrow button to
Up or Down Arrow
Enter button to set the
Installation and Configuration
3-11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Designjet 650c c2858aDesignjet 650c c2859a

Table of Contents