Power Trim And Tilt Will Not Operate - Yamaha F150 Owner's Manual

Trouble Recovery
(1) Turn the main switch to the "
position.
(2) Remove the fuse box cover.
(3) If the fuse is secured using screws, re-
move the screws, and then remove the
fuse. Install a spare fuse of the proper
amperage, and then tighten the screws.
2 1
1. Fuse box cover
2. Spare fuse (10 A, 15 A, 20 A, 30 A, 60 A, 70
A)
3. Fuse puller
10
11
1. Fuel feed pump fuse (10 A)
2. Main switch / PTT switch fuse (20 A)
3. Shift actuator fuse (15 A)
4. Starting switch fuse (30 A)
5. Ignition coil / Fuel injector / Variable cam-
shaft timing / Engine ECM (Electronic con-
trol module) fuse (30 A)
6. Electric throttle valve fuse (10 A)
7. Fuel pump fuse (15 A)
8. Engine main fuse (60 A)
9. Isolator fuse (60 A)
10.Power STRG fuse (70 A)
98
" (off)
1
2
2
3
8
11
1
2
3
4
11
5
6
7
9
11.Screw
(4) If the fuse is not secured using screws,
remove the fuse using the fuse puller,
and then install a spare fuse of the proper
amperage.
1
1. Fuse puller
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU29529

Power trim and tilt will not operate

EWM02331
Never get under the engine while it is tilt-
ed. Severe injury could occur if the out-
board motor accidentally falls.
If the outboard motor cannot be tilted
up/down using the power trim and tilt unit,
e.g. because of a discharged battery or a fail-
ure with the unit itself, the outboard motor
can be tilted manually.
(1) Stop the engine.
(2) Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
ZMU04337