Table of Contents
Advertisement
EMU29492
Replacing fuse
If the fuse has blown on an electric start
model, open the fuse box and use a fuse
puller to replace the fuse with a spare one of
the proper amperage.
EWM00630
WARNING
Be sure to use the specified fuse. An in-
correct fuse or a piece of wire could allow
excessive current flow. This could cause
electric system damage and a fire hazard.
ECM01382
CAUTION:
If a main fuse has blown, be sure to also
G
check the other main fuse.
If the outboard motor is operated after a
G
main fuse has blown charging capabili-
ty will be insufficient, and the engine
will not start.
Trouble Recovery
4
3
2
5
1
1. Electrical cover
2. Fuse holder
3. Fuse (20A x 3, 30A x 1, 80A x 2)
4. Spare fuse (20A, 30A, 80A)
5. Fuse puller
1
1. Fuse puller
NOTE:
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU29522
Power trim and tilt / power tilt will not
operate
If the engine cannot be tilted up or down with
the power trim and tilt / the power tilt because
of a discharged battery or a failure with the
power trim and tilt unit / the power tilt unit, the
engine can be tilted manually.
1.
Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
3
4
ZMU04009
ZMU03562
72
Advertisement
Table of Contents
