Disassembling the trim cylinder
1. Hold the power trim and tilt unit 1 in a
vise using aluminum plates a on both
sides.
2. Loosen the trim cylinder end screw 2,
and then remove it.
WARNING
Make sure that the ram is fully extended
before removing the end screw.
Cylinder-end screw wrench:
90890-06588
3. Drain the power trim and tilt fluid.
Disassembling the tilt cylinder
1. Hold the tilt cylinder 1 in a vise using
aluminum plates a on both sides.
6C13G11
2
S68S7040
Tilt cylinder and trim cylinder
NOTE:
Place the tilt cylinder in the vise horizontally.
2. Loosen the tilt cylinder end screw 2, and
then remove it.
CAUTION:
Do not damage the check valve b when
loosening the end screw.
Cylinder-end screw wrench:
New: 90890-06568
Current: 90890-06544
3. Hold the tilt ram end in a vise using alu-
minum plates on both sides.
4. Remove the bolt 3, then the tilt piston
4.
1
2
3
4
5
6
7
8
9
7-42