Power Led - ESI IVX20 Installation Manual

Hardware overview/installation
64-Key Expansion Console connection
Each Expansion Console is connected to a Digital Feature Phone with a special RJ14 cable assembly
(provided with the Console). Once connected, it automatically identifies itself to the system and
can be programmed as an adjunct to the Feature Phone to which it is connected.
Connect the shortest part (one-inch) of the expansion cable to the IVX Digital Feature Phone.
1.
Connect the 11-inch part of the expansion cable to the 64-Key Expansion Console.
2.
Plug the longest portion of the expansion cable into the telephone wall jack.
3.
To keep cables out of the way, thread the two cables connecting the Digital Feature Phone and
4.
the Expansion Console into the slots on the bottom of the Phone and the Console.
Program the keys on the Expansion Console using the same procedure as with the Digital Fea-
5.
ture Phone (press PROG/HELP 2).
Label the paper overlay to show how the keys are programmed, either with ESI Installer
6.
or manually.
Install the labeled paper overlay on the 64-Key Expansion Console.
7.
Install the clear plastic overlay over the paper overlay to protect it.
8.
Use the provided Velcro
9.
right side of the IVX Digital Feature Phone.

Power LED

The Power LED is located on the top-right side of the cabinet and is illuminated when power is
being applied to the system. The LED blinks periodically to indicate that the main processor
is operational.
Note: Upon power-up, approximately 90 seconds are required for the system to configure.
The Power LED will blink three times to indicate that the power up sequence has
been completed.
B.14
®
tape to attach the left side of the 64-Key Expansion Console to the
IVX 20