Seat Removal; Seat Height; Arm Width Adjustment - Shoprider Grande TE-9AS User Manual

Continued.....

Seat Removal

To remove the seat, lift the seat swivel lever and at the same time lift the seat up, away
from the scooter. Fitting the seat is the reverse of the above procedure. Ensure the seat
is properly relocated after fitting by operating the swivel function.
Do not hang baggage or other objects on the back of the seat as this may affect
stability.
Seat Height Adjustment
Remove the seat as previously
described. Loosen the securing screw
and remove the locking pin. Adjust the
seat post to the desired height. Insert
the locking pin ensuring the retaining
clip is refitted and tighten the securing
screw. Re-fit the seat as above.
The higher the seat is adjusted; stability may be affected due to the higher centre of
gravity.
Arm Width Adjustments
On each side of the seat towards the back there are two hand knobs, these are to
adjust the width of the armrests or to remove then for transport.
Turn the hand knobs anti-clockwise to loosen. Once the knobs are loose you will be able
to adjust the armrests in or out to the desired width. Re-tighten when a comfortable
width has been achieved or remove the armrests completely for transport.
If removing the armrests for transport, ensure that the hand knobs are re-tightened to
avoid them rattling loose and falling out.
Do not apply full body weight to the armrests for transferring. Lift the arm up out of the
way to transfer to another seat.
7