Adjustments; Folding The Tiller (For Transportation); Seat Removal; Seat Height - Shoprider Altea SL7-3 User Manual

Adjustments

Folding the Tiller Assembly
(For transport purposes) (Fig. 1)
Loosen the hand knob at the front of
the lower tiller stem and fully fold the
tiller into the base and retighten the
knob.
Do not carry the scooter by the
tiller stem.
Seat Removal (Fig. 2)
To remove the seat, fold down the back of the
seat. Slacken the hand lever (1) and gently lift
the seat away from the rear chassis.
Always ensure that the seat is securely
locked in the forward facing direction when
driving the scooter. Do not hang baggage
or other objects on the back of the seat as
this may affect stability.
Seat Height Adjustment (Fig. 2)
Remove the seat as previously described.
Remove the locking pin (2) and set the seat to
the height required (there are two heights
available).
The higher the seat is adjusted, stability
may be affected due to the higher centre of
gravity.
Arm Adjustments (Fig. 3)
On each side of the underside of the seat towards the
back there are two hand knobs. These are to adjust
the width of the armrests or to remove then for
transport.
Turn the knobs anti-clockwise to loosen. Once the
knobs are loose you will be able to adjust the
armrests in or out to the desired width. Re-tighten
when a comfortable width has been achieved or
remove the armrests completely for transport.
If removing the armrests for transport, ensure that
the knobs are re-tightened to avoid them rattling
loose and falling out.
Do not apply full body weight to the armrests for
transferring.
Hand Knob
7
Fig 1
Fig 2
1
2
Fig 3
Hand
Knobs