Adjustments; Tiller Angle Adjustment (Fig. 5); Seat Slide & Swivel Adjustment (Fig. 6); Seat Removal (Fig. 7) - Shoprider 889-3XLS User Manual

Tiller Angle Adjustment (Fig. 5)

On the left hand side at the base of the tiller
is a red lever. Push the lever to release the
pin and select the desired tiller angle. Refit
the pin into one of the five location holes to
lock tiller in place.
DO NOT DRIVE SCOOTER IF TILLER IS
NOT SECURED.
Seat Slide & Swivel Adjustment (Fig. 6)
Pulling up on the seat black slide lever
allows the seat position to be adjusted
forward or backward. Release the lever and
the seat will lock in that position. Under the
right side of the seat there is a spring loaded
red lever. Pulling up on the lever allows the
seat to swivel, when released the seat will
lock into one of four positions.

Seat Removal (Fig. 7)

Fold down the back of the seat. Pull up the
red swivel seat adjustment lever (fig. 6) and
lift seat off. Remove the hand knob and
locking pin that secures the seat adaptor.
Lift the seat adaptor out of the seat post.

Seat Height Adjustment (Fig. 7)

Remove seat as described above. Loosen
the seat tightening hand knob.
height can be adjusted to 5 different settings
by inserting the steel locking pin in the
required hole. Retighten the hand knob and
replace the seat.

Armrest Width Adjustments (Fig. 8)

On the underside of the seat there are two
hand knobs, one either side. Loosening the
hand knob allows the arm rest to be adjusted
to the required width, or removed for
transportation.
DO NOT USE SCOOTER WITHOUT THE
ARM RESTS BEING FITTED & SECURED.
12/29/2004

ADJUSTMENTS

Tiller
Angle
Adjustment
Lever
Swivel Seat
Adjustment
Lever
Seat
Adaptor
Seat
Tightening
Hand Knob
The seat
Armrest
Adjustment
Hand Knob
8
Figure 5
Figure 6
Seat
Locking
Pin
Figure 7
Figure 8
Seat Slide
Lever