Shoprider Grande TE-9AS User Manual page 10

Continued.....
On / Off Key
Simply insert the key and turn clockwise to switch the power on. The display will light up
to indicate the power is on. There may be a slight delay before the thumb levers
operate as the controller checks the scooters circuits. Never leave the key in the switch
unattended to prevent unauthorised use. Do not switch the power off to stop the scooter
unless it is an emergency. The scooter will stop very abruptly if stopped in this way.
Finger Lever (Wig-Wag)
The finger levers control the reverse and forward motion of the scooter – see 'Starting To
Drive' for operation. Remember, more pressure = more speed. Release the lever and
the scooter will automatically come to a safe stop as the electromagnetic brake is
applied. Always release the lever if the scooter behaves erratically.
Horn Button
The button operates the scooters horn. This should only be used to warn others of your
presence and not as a rebuke of any form.
Hi / Low Speed Switch
This will switch the scooter between a maximum 4mph & 8mph mode. 8mph may only
be used when driving on the road.
Take notice of the advice given regarding maximum speed when in pedestrian areas.
Emergency Handbrake
This is located on the left side of the tiller.
Should all emergency procedures fail, the emergency handbrake operates a brake on
the rear wheel. DO NOT use this during normal driving as it could damage the
electronics.
10