Reverse Sensing Switch; Leveling Front Mower - Jacobsen HR 5111 Parts And Maintenance Manual

3.14 REVERSE SENSING SWITCH ________________________________________________

1. Adjust actuating rod (Z) so tractor shifts into 2WD at
approximately 0.5 m.p.h. in reverse.
2. Loosen nut and turn rod end counterclockwise to
decrease speed or clockwise to increase speed.
3. Tighten nut and test machine.
4. If adjustment cannot be made, contract your
authorized Textron Turf Care And Specialty Products
dealer.

3.15 LEVELING FRONT MOWER__________________________________________________

1. Before leveling the front deck, the tractor tires and
caster wheels must be properly inflated. The cutting
height is directly related to the radius of the tire.
2. Set the cutting height of the front mower to 5-1/2 in.
(140 mm).
3. Rotate all blades so that one end of the blade (A) is
pointing forward.
4. Fully lower front deck. Measure from the ground to
point (A) and from the ground to point (B). Point (B)
must be 1/8 in. (3 mm) higher than point (A).
5. Add or remove shims (C) as required between
bumper pad (D) and lift arm (E).
6. Once the front mower has been properly leveled,
the cutting height may be readjusted without
changing the shims. It may be necessary to re-level
the deck if there is a change to the tires.
ADJUSTMENTS
A
B
B
E
3
Z
Figure 3M
A
A
B
Figure 3N
D
C
Figure 3O
GB-13