Jacobsen HR 5111 Operation Manual
Rotary mower
Hide thumbs
Also See for HR 5111:
- Service and repair instructions (339 pages) ,
- Parts and maintenance manual (247 pages) ,
- Maintenance manual (150 pages)
Related Manuals for Jacobsen HR 5111
Summary of Contents for Jacobsen HR 5111
- Page 1 4103523-Rev B Safety & Operation Manual HR 5111 Rotary Mower 69116 – Kubota V2203 with ROPS Serial Number 5901 and Up 69158 – Kubota V2203 with ROPS, Europe...
-
Page 2: Table Of Contents
CONTENTS 5 ....... . . OPERATION 1 ........CONTENTS CONTENTS Daily InspectioN.......... -
Page 3: Safety
SAFETY SAFETY OPERATING SAFETY ______________________________________________________ WARNING EQUIPMENT OPERATED IMPROPERLY OR BY UNTRAINED PERSONNEL CAN BE DANGEROUS. Familiarize yourself with the location and proper use of all controls. Inexperienced operator’s should receive instruction from someone familiar with the equipment before being allowed to operate the machine. 1. -
Page 4: Important Safety Notes
SAFETY IMPORTANT SAFETY NOTES _______________________________________________ This safety alert symbol is used to alert you to potential hazards. DANGER - Indicates an imminently hazardous situation which, if not avoided, WILL result in death or serious injury. WARNING - Indicates a potentially hazardous situation which, if not avoided, COULD result in death or serious injury. -
Page 5: Decals
DECALS DECALS DECALS _________________________________________________________________ Familiarize yourself with the decals. They are critical to the safe operation of the machine. REPLACE DAMAGED DECALS IMMEDIATELY. DANGER PRECAUCION To avoid injury when working with battery: 1. No opere esta maquina sin previo entrenamiento, instruccion y sin haber 1. - Page 6 DECALS CAUTION Do not operate tractor with horn sounding. Horn will sound to warn of overheated engine or hydraulic system. See instructions in Operator’s manual to properly clean the radiator or oil cooler and check fluid level. When implements become clogged, disconnect power and stop engine before cleaning. Keep hands, feet and clothing away from power driven moving parts.
-
Page 7: Controls
CONTROLS ICONS ___________________________________________________________________ CONTROLS Hour Meter Engine Read Manual Engine Throttle Start High Coolant Parking Brake Diesel Fuel Implement Position Temperature Left Center Right Traction Weight Transfer Drive Mode Cruise Control to Decks Forward Reverse Momentary Engage Disengage Increase Decrease Engine Oil Air Filter Differential Lock... - Page 8 CONTROLS Steering Tilt Lever Left Wing Lift/Lower Lever Cruise Control Switch Differential Lock Front Lift/Lower Lever Tachometer Service Brake Right Wing Lift/Lower Lever Fuel Gauge Traction Pedal Horn / Test Switch Volt Meter W Hour Meter Parking Brake PTO Switch Ground Pressure Wing Mower Switch Circuit Breakers...
-
Page 9: Control Descriptions
CONTROLS CONTROL DESCRIPTIONS __________________________________________________ A. Steering Tilt Lever J. Left Wing Lift/Lower Lever Used to adjust position of steering console. Pull Raises and lowers left wing mower. Push lever lever back to release and push lever forward to lock forward to lower left wing mower. Pull lever back to console in place. -
Page 10: System Sentry
CONTROLS 12 14 R. 2WD / 4WD Switch W. Hour Meter Used to switch tractor between 2WD and 4WD Records engine operating hours. The hour meter can mode. Depress front of switch for 4WD in forward be used to time maintenance intervals or mowing direction only. - Page 11 CONTROLS Left Engine Engine Charge Return Hydraulic Charge Glow Right Turn Coolant Pressure Filter Filter Filter Plug Turn Signal Light Temperature Light Light Temperature Light Light Light Signal Light Light Figure 4A Alert Action Stop tractor immediately, lower implements and shut off engine! Inspect oil Engine Oil Pressure - Alarm sounds level in engine.
-
Page 12: Operation
OPERATION DAILY INSPECTION________________________________________________________ OPERATION 2. Check the fuel supply, radiator coolant level, CAUTION crankcase oil and hydraulic oil. All fluids must be at the full level mark with engine cold. The daily inspection should be performed only when 3. Make sure all mowers are adjusted to the same the engine is off and all fluids are cold. -
Page 13: Operating Procedures
OPERATION OPERATING PROCEDURES _________________________________________________ WARNING A Rollover Protection Structure (ROPS) for this tractor is included. Seat belts must be worn whenever a ROPS is installed on the tractor. Always keep seat belt snugly adjusted. DO NOT use seat belts on a tractor without a ROPS. If a ROPS is installed and the tractor is overturning, hold onto the steering wheel. -
Page 14: Starting
OPERATION STARTING _______________________________________________________________ IMPORTANT: Do not use starting assist fluids. Use of such fluids in the air intake system may be potentially explosive or cause a “Runaway” engine condition and could result in serious engine damage. CAUTION 1. Make sure fuel shut off valve is completely open and 1. -
Page 15: To Drive / Transport
OPERATION TO DRIVE / TRANSPORT____________________________________________________ Read and follow all safety notes contained in this manual 4. Always bring the tractor to a complete stop before when driving or transporting tractor. Refer to Section 5.3 changing travel direction or shifting from 2WD to for general operating instructions. -
Page 16: Mowing
OPERATION MOWING_________________________________________________________________ a. For complete even cutting, overlap swaths by a WARNING few inches. b. When cutting tall grass, cut grass higher than To prevent serious injuries, keep hands, feet and desired the first time so mower will clear unseen clothing away from cutting unit when the blades are obstructions and will not scalp if ground is rough. -
Page 17: 5.11 Daily Maintenance
OPERATION 5.11 DAILY MAINTENANCE______________________________________________________ Important: For more detailed maintenance information, WARNING adjustments and maintenance/lubrication charts, see the Parts & Maintenance manual. To prevent serious injury from hot, high pressure oil, never use your hands to check for oil leaks, 1. Park the tractor on a flat, level surface. Fully lower use paper or cardboard. -
Page 18: Notes
NOTES NOTES... - Page 20 Equipment from Jacobsen is built to exacting standards ensured by ISO 9001 and ISO 14001 registration at all of our manufacturing locations. A worldwide dealer network and factory trained technicians backed by Textron Parts Xpress provide reliable, high-quality product support.