Save And Test - Midtronics Celltron ULTRA Instruction Manual

Celltron ULTRA
change with jar temperature. To compensate, the
percentage of the reference value.
TEMP. UNITS (check boxes)
DEGREES F
DEGREES C
TEMPERATURE (scrolling/numeric)
Range: 0 to 50 °C ( 32 to 122 °F).
AC RIPPLE
ENTER
Press to select the string's AC ripple.
AC RIPPLE (scrolling/numeric)
Select from 0.000 to 99.999 volts.
DC FLOAT V.
ENTER
Press to select the string's DC float voltage.
DC FLOAT (scrolling/numeric)
Select from 0.00 to 600.00 volts.
DC FLOAT A.
ENTER
Press to select the string's DC float current.
DC FLOAT A.(scrolling/numeric)
Select from 0.000 to 99.999 amps.

SAVE AND TEST

This option enables you to save your test parameters and start a test. If the analyzer is not connected to a jar, it
prompts you to connect to one before it starts the test.
SAVE AND CONTINUE
This option enables you to save your settings without starting a test. When you press
saved under the string name you created. You are then returned to the BATTERY SETUP menu.
OPEN (icon)
To use a saved test setup, press
parameters without erasing string test data for completed tests.
STRING INFO (scrolling)
Scroll to the string name to start the test.
WARNING
The analyzer will warn you that a test using the string name/setup was already performed. If you want to
change parameters, it will recommend that you use the NEW (TEST) function. Press
BACK
the
STRING INFO (scrolling parameters list)
The parameters list will appear. Verify that these are the parameters you want to use, and scroll to SAVE
AND TEST. Otherwise, make changes using the NEW (TEST) function.
ENTER
. The parameters list will appear; however, you cannot change certain
key to cancel.
ULTRA
uses the temperature you select to adjust the
11
• •
Chapter 2: Description
ENTER
, your test setup is
ENTER
to continue or
Main Menu (menu icon)