Ptz; Ptz Control (For Ptz Devices Only) - EverFocus PARAGON 264x1 User Manual

event recording period; blue indicates a video-loss-event recording period, red indicates an alarm-event recording
period.
10. The "+" and "-" signs are used to decrease or increase the time scale of the time bar. Press "+" or "-" to select between
scale levels L1 ~ L5. When changing between these levels, the start time and end time of the time bar will change.
L1: The bar's length represents 2 days of recorded footage
L2: The bar's length represents 30 hours of recorded footage
L3: The bar's length represents 1 hour of recorded footage
L4: The bar's length represents 10 minutes of recorded footage
L5: The bar's length represents 1 minute of recorded footage
11. Express copy: Press this icon to start copying to a connected device while the camera is in playback mode
12. Playback speed indicator
13. Press "X" to close the playback bar. This will allow the Play or Back functions to continue, if they are active.
14. Start date/time of the time bar (the left-most point of the time bar)
15. Current playback moment (the time indicated by the slider)
16. End date/time of the time bar (the right-most point of the time bar)

4.2 PTZ

4.2.1 PTZ Control (for PTZ devices only)

Once you have selected the PTZ camera of your choice, right-click to bring up the menu bar and click on
the PTZ dome icon to open that channel full-screen and display the camera's PTZ Control Bar (see the
image on the right).
The following actions can be performed using the PTZ Menu:
1. Use the Direction Arrows (up, down, left, right) to move the camera to the desired direction and angle.
2. Zoom: Click "Z+" to zoom in, or "Z-" to zoom out.
3. Focus: Click "F+" to focus far, or click "F-" to focus near.
4. Iris: Increase the amount of light by clicking "I+" or decrease it by clicking "I-".
5. To program a preset position (if supported by the camera)
a. Move the PTZ camera to the desired position
b. Click the "Preset" button
c. Click the number of the desired position (this will be displayed in the preset ID number box)
d. Click the "Set" button
6. To jump to a preset position
a. Click the "Preset" button
b. Click the number of the desired position
c. Click the "Go" button (under the "9" button)
7. Shortcut jump to presets #1-9
a. Click the desired number's button without clicking any other buttons
b. The camera will automatically jump to that preset position
8. Steps to delete a preset position (if supported by the camera)
a. Click the "Preset" button
b. Click the number of the desired position
c. Click the "Delete" button
9. For Auto Pan
20