Layout; Opening A Channel To Full-Screen; Switching Channel Positions - EverFocus PARAGON 264x1 User Manual

16ch dvr

Table of Contents

4.3 LAYOUT

This DVR offers several display modes, similar to the ones shown below:

NOTE: PIP (Picture in Picture) display is not available in Playback mode

To change the layout, follow the steps below:

With the mouse: Right-click to bring up the menu bar and click

, then click on the desired layout choice.

With the front panel: Push one of the six Layout buttons on the front panel that is closest to the layout you want.

Mouse: Double left-click on the selected channel to put that camera in full-screen mode. Double left-click again on the

screen to return to the multi-channel layout.

Front Panel: Press any channel selector button to bring that channel to full-screen mode. Click any of the six Layout buttons

to return to a multi-channel layout.

Use this function to switch channel positions within a multi-channel display or sequence

1. Pre-select a camera

2. Press the Channel ("switch") button

3. On the Channel bar, click on the channel position number you wish to assign to the selected channel. The camera

channel displayed in that position will be switched to that of the pre-selected channel.

EXAMPLE: If you select camera1 and open the Channel menu bar and choose camera10, then camera10 will be displayed

in Position 1, and camera1 will be displayed in Position 10. NOTE : if, for example, you later switch camera16 with camera1,

camera16 will be displayed in Position 10, and camera1 in Position 16. To eliminate confusion, show the camera channel ID

numbers on-screen by pressing the front-panel Display button a few times (and make sure the screen shows the 16-channel

simultaneous view by clicking the 16-channel-view shortcut button at the top left of the front panel).

Table of Contents