Record & Play; Record - EverFocus PARAGON 264x1 User Manual

Pre-alarm Record: Check this box to add to the motion-
event recording (recorded on the hard disk) footage from 5
seconds before the video-loss event. (This Pre-alarm
recording's frame rate will follow the "Normal" frame rate
settings.)
Buzzer: Check this box to activate the DVR's buzzer when a
video-loss event occurs.
Email Notify: Check this box to enable email notification
when a video loss event occurs. Email operation requires
that valid email settings have been entered in the Network
Setting/Email setup screen. (See the Email section for more
information.)
Network Alarm: Check this box to send out a network alarm
to a client PC when video loss occurs. (This feature requires PowerCon software on the client PC and proper settings for
the Alarm Server in the Network Setup menu; see the Alarm Server section for more information.)
Alarm Output: Selecting "None" will leave this function disabled. Selecting one of the four numbers will instruct the DVR to
transmit a signal through the alarm output relay marked with the same number (at the back of the DVR) when a video-loss
event occurs on this camera channel. This will only work if a device has been connected to the relevant alarm output relay.
Output Type: If an Alarm Output has been selected above this setting, this setting will decide how that Output is transmitted
when a motion event occurs.
Timeout: The alarm output lasts for a set period of time. If this option is selected, a field will appear under this field for
setting the period duration. Setting options are 1~150 seconds.
Permanent: The alarm will remain on until the user presses the "Enter" key on the front panel, or resets the alarm
configuration.
Transparent: The alarm output continues as long as video loss is detected.
Trans+Timeout: The alarm output continues as long as video loss is detected, then it continues for the set time period.
Timeout Duration: This period can be from 1 to 150 seconds.
Apply To: This button can be used to copy the video loss settings to other cameras. Select which cameras you wish to
copy to. "Select All" selects all cameras, "Unselect All" deselects all cameras. Click "OK" to copy the settings or "Cancel" to
exit without copying.
5.3 RECORD & PLAY
On the right is a screenshot of the RECORD & PLAY
SETTING MENU. This menu is used to configure basic
recording and playback settings.

5.3.1 Record

Record Overwrite: Check this box and the disk will begin
overwriting when full. NOTE: Unless this box is checked, THE DVR WILL STOP RECORDING WHEN THE DISK IS FULL.
35