Table of Contents
Advertisement
installation
|
34
BACK UP
BATTERY INSTALL
1. Open the access panel of the unit.
Access Panel
2. Unscrew the 2 screws (1 on each side), from
the Valve Cover Plate.
Screw 1
Valve Cover Plate
3. Take the valve cover plate out.
4. There will be the battery compartment sitting
in the front.
4. Install 4 AA batteries into the box and slide it
back to its original place.
5. Reverse steps 3-1 to reinstall.
NOTE:
Remove the batteries when normal operation
is resumed as the heat will drain the bat-
tery power rapidly.
34 |
Hampton® H35-10 Direct Vent Freestanding Gas Stove
OPTIONAL
BRICK PANEL
1) Remove the front cast. (See page 13
instructions) and glass front (see page 41 for
Glass Replacement instructions).
2) Remove the log set if installed.
3) Insert the back brick panel first by carefully
slipping it between the back wall of the firebox
and the rear log bracket.
4) Before installing the side brick panels, loosen
the screws for the brick tabs enough so that you
can slide the brick tabs on to the screws easily
but that the tabs are secure. For the location
of the side brick tab screws see Diagram 1.
Screw 2
5) Put the side panels in next. Slide them in from
the front and push them flat up against the
wall. Be very careful not to scratch them on
the firebox hardware.
Brick
tab screw
Left
Side
Panel
6) Install the brick tabs (refer to Diagram 2).
for
Back Panel
Back
brick
panel
Side
brick
panel
Diagram 1
Right
Side
Panel
Brick
Brick Tab
Tab
Screw
Diagram 2
Hide quick links:
Advertisement
Table of Contents
