KVH Industries TracPhone V11IP User Manual page 69

TracPhone V11-IP User's Guide
Network Configuration
70
3. Connect the Operations computers and/or network devices to
the "User Ethernet" ports on the ICM that are designated "Ops
LAN," if any.
Figure 6-13 Crew-2 Configuration Wiring Example
ICM
User Ethernet
1 2 3 4
Bridge PC Officers PC
4. To enable the ICM's built-in wireless access point (WAP) for
Wi-Fi access, follow the steps in
page 78.
5. Make sure all computers are configured for DHCP addressing
(see "Configuring Computers for DHCP" on page
connected to the ICM (via Ethernet cables or Wi-Fi) will receive
IP addresses from the ICM via DHCP. The ICM serves as a
router.
6. If you selected the Crew-4 configuration, connect your static IP
device to "User Ethernet" port 4 and follow the additional
setup steps explained in
NOTE: By default, the ICM has a gateway of 192.168.5.1 and assigns IP
addresses in the 192.168.5.100-200 range. If this configuration conflicts with
an existing onboard network, you may change the settings at the TracPhone
V11-IP web interface (go to Settings > Network Settings). See
Settings on ICM" on page 86
User
Login
Crew Mobile
Devices
User
Login
Crew PC
"Wireless Settings" on
"Static IP Configuration" on page
for details.
80). Devices
64.
"LAN