KVH Industries TracPhone V11IP User Manual page 124

TracPhone V11-IP User's Guide
Troubleshooting
128
Antenna/ACU Status
Message
ANTENNA STATE
ANTENNA DC INPUT
CURRENT AZ/EL
CURRENT SKEW
IPACU DC INPUT
IPACU ENET MODEM
PORT STATE
MTA/RSM(GPRS) Status
Message
MTA STATUS
RSM (GPRS) STATUS
Description
General status of the antenna; must be
"Tracking" to connect to mini-VSAT
Broadband
DC voltage measured at the antenna's
circuit board; should be between
44 VDC and 52 VDC
Azimuth and elevation at which the
antenna is currently pointing; azimuth
is relative to vessel heading if heading
data is available, or the antenna's
"Forward" arrow (bow) if heading
data is not available
Current skew angle of the antenna's
LNB
DC voltage measured at the ICM's
power input; should be between
23 VDC and 25 VDC
Status of the ICM's Ethernet
connection to its built-in modem;
"Link" indicates the jumper cable is
connected between B1 and B2 on the
ICM's rear panel
Description
Status of the ICM's built-in MTA;
"Registered" indicates the MTA is
connected to the voice service
Status of the antenna's built-in remote
service and support module (GPRS
modem); "Registered" indicates a
good GPRS cellular connection