KVH Industries TracPhone V11IP User Manual page 113

No. Description
231 Error: The antenna's RF software might be corrupted. Try
updating the software (see
page 143).
234 Error: The antenna is not receiving satellite signal strength
(RSSI) data from the ICM. Try these steps:
• Turn the ICM off, then back on.
• Check the wires on the back of the ICM.
• Check the data cable.
235 Error: The antenna has lost RF communications. Contact
KVH.
241 Error: The antenna's main board detects a power failure.
Contact KVH.
243 Error: The antenna's BUC is not receiving the required 10
MHz reference signal from the ICM. Check the transmit
(TX) RF cable.
244 Error: The antenna's main board has lost communications
with the BUC. Contact KVH.
245 Error: The antenna's main board is unable to configure the
BUC. Contact KVH.
246 Error: There is an open circuit in the LNB power wiring, or
the antenna's LNB might be faulty – contact KVH.
247 Error: There is a short circuit in the LNB power wiring, or
the antenna's LNB might be faulty – contact KVH.
248 Error: The antenna's LNB is not receiving the required 10
MHz reference signal from the ICM. Check the receive (RX)
RF cable.
249 Error: The internal temperature of the antenna's SSPA
(solid state power amplifier) exceeds acceptable limits.
Turn off the system and allow it to cool. If the problem
persists, the SSPA might be faulty. Contact KVH.
250 Error: The antenna's main board has lost communications
with the power/thermal module. Contact KVH.
251 Error: The antenna's main board is unable to configure the
power/thermal module. Contact KVH.
TracPhone V11-IP User's Guide
"Software Updates" on
Troubleshooting
117