Clearing No-Transmit Zones - KVH Industries TracPhone V11IP User Manual

Clearing No-Transmit Zones

You can clear all no-transmit zones from the system's memory. Unlike
disabling zones, clearing zones permanently deletes them.
Clearing no-transmit zones allows the antenna to transmit in any
direction without restriction. Make sure everyone stays the
minimum safe distance away from the antenna while it is in use
(see "RF Radiation Hazard Area" on page
NOTE: This procedure explains how to clear no-transmit zones using the
TracPhone V11-IP web interface. If you prefer, you may use the front panel
LCD menu instead (go to Diagnostic Tools > Factory Reset).
To clear the no-transmit zones, follow these steps:
1. At the TracPhone V11-IP web interface, click the Settings tab.
Then click No-Transmit Zones.
2. Click Edit.
3. If the Login window appears, log in with the Administrator
password.
4. In No-Transmit Zone Ranges, click Clear Zones.
5. At the confirmation message, click Clear Zones.
Figure 4-8 Clearing No-Transmit Zones
CAUTION
TracPhone V11-IP User's Guide
No-Transmit Zones
6).
39