KVH Industries TracPhone V11IP User Manual page 111

No. Description
125 Warning: The ICM has lost communications with the GPRS
modem (remote service & support module) inside the
antenna. Check the data cable and the wires on the back of
the ICM.
127 Error: The antenna is not accepting the no-transmit zones
setup from the ICM. Contact KVH.
128 Warning: The software update failed. Retry updating the
software. If it fails again, check the data cable and the wires
on the back of the ICM.
200 Warning: The antenna is not receiving adequate DC power
from the ICM (this DC voltage must be present to enable
the antenna's AC power circuit). Check the data cable and
the wires on the back of the ICM.
202 Error: The antenna's main board has lost communications
with the skew and cross-azimuth motors. Contact KVH.
203 Error: The antenna's main board has lost communications
with the azimuth and elevation motors. Contact KVH.
204 Error: The antenna's main board has lost RF
communications. Try updating the software (see
Updates" on page
205 Error: The antenna's azimuth motor has a power failure.
Contact KVH.
206 Error: The antenna's azimuth motor or limit switch failed.
Contact KVH.
207 Error: The antenna's elevation motor has a power failure.
Contact KVH.
208 Error: The antenna's elevation motor or limit switch failed.
Contact KVH.
209 Error: The antenna's main board has lost communications
with the sensor module. Contact KVH.
210 Error: The antenna's sensor module failed. Contact KVH.
211 Error: The antenna's sensor module has a power failure.
Contact KVH.
TracPhone V11-IP User's Guide
143).
Troubleshooting
"Software
115