Establishing No-Transmit Zones - KVH Industries TracPhone V11IP User Manual

Establishing No-Transmit Zones

To configure a no-transmit zone, follow these steps:
1. Identify the necessary azimuth range for the zone (see
"Identify the Azimuth
2. Identify the necessary elevation range for the zone (see
"Identify the Elevation Range" on page
3. At the TracPhone V11-IP web interface, configure a no-
transmit zone for that combination of azimuth and elevation
ranges (see
Interface" on page
Identify the Azimuth Range
First, you need to determine the necessary azimuth range for the no-
transmit zone(s). You will need to enter, in clockwise order, the
beginning and ending azimuths that define the outer boundaries of the
zone, relative to the antenna's forward arrow, which should be
pointing toward the bow.
NOTE: Each no-transmit zone must span at least 5º. Therefore, be sure to set
beginning and ending azimuths at least 5º apart.
Figure 4-3 Beginning and Ending Azimuths Defining a No-Transmit Zone (Example)
315
270
225
Range").
"Configure the No-Transmit Zone(s) at the Web
35).
Beginning Azimuth
FROM
015
No-Transmit Zone
000
(Example)
Forward
Antenna
135
180
TracPhone V11-IP User's Guide
No-Transmit Zones
34).
Ending Azimuth
TO
080
090
33