KVH Industries TracPhone V11IP User Manual page 115

No. Description
262 Warning: The antenna's power/thermal module is not
operating on adequate power. The power/thermal module
or power supply might be faulty. Contact KVH.
263 Warning: The antenna's BUC is not receiving the required
10 MHz reference signal from the ICM. Check the transmit
(TX) RF cable.
264 Warning: The antenna's LNB is not receiving the required
10 MHz reference signal from the ICM. Check the receive
(RX) RF cable.
265 Warning: The GPS is unable to acquire a fix. Check for
blockage or RF interference around the antenna.
401 Warning: No NMEA 0183 heading input detected. Check
the NMEA 0183 talker and its wires connected to the back
of the ICM.
404 Warning: Antenna is unwrapping its coiled internal cable.
Normal operation should resume within one minute.
410 Warning: The ICM has lost Ethernet communications with
its built-in modem. Check the jumper cable connecting
"B1" to "B2" on the back of the ICM.
411 Warning: The antenna cannot find an available service
satellite. You are located outside the coverage area.
412 Warning: The ICM is not receiving the proper DC voltage
from its power suppl(this DC voltage must be present to
enable the antenna's AC power circuit)y. Check the power
cable
413 Warning: The antenna is waiting for GPS to acquire a fix.
414 Warning: The antenna is using position data from a backup
GPS device and not its built-in GPS.
TracPhone V11-IP User's Guide
Troubleshooting
119