Creating Scanned Images Depending On Intended Use; Scanning Only One Side Of A Document - Fujitsu scansnap ix500 Operator's Manual

Creating Scanned Images Depending on
Intended Use
This section explains about various ways of using the ScanSnap.

Scanning Only One Side of a Document

By default, the ScanSnap scans in duplex mode.
To perform simplex scanning, perform the following steps to change the setting.
1.
Select [Settings] from the ScanSnap Manager menu.
For details about the ScanSnap Manager menu, refer to
(Mac OS)" (page
The ScanSnap setup window appears.
2.
In the [Scanning side] pop-up menu in the [Scanning] tab, select
[Simplex Scan (Single-sided)].
3.
Click the [Apply] button in the ScanSnap setup window.
4.
Click the [
setup window.
Creating Scanned Images Depending on Intended Use (for Mac OS Users)
39).
] button in the upper left corner to close the ScanSnap
381
"ScanSnap Manager Menu