Creating Scanned Images Depending On Intended Use; Scanning Only One Side Of A Document - Fujitsu scansnap ix500 Operator's Manual

Creating Scanned Images Depending on
Intended Use
This section explains about various ways of using the ScanSnap.

Scanning Only One Side of a Document

By default, the ScanSnap scans in duplex mode.
To perform simplex scanning, perform the following steps to change the setting.
1.
Select [Scan Button Settings] from the Right-Click Menu.
For details about the Right-Click Menu, refer to
37).
The ScanSnap setup dialog box appears.
2.
In the [Scanning side] drop-down list in the [Scanning] tab, select
[Simplex Scan (Single-sided)].
3.
Click the [OK] button to close the ScanSnap setup dialog box.
4.
Load a document in the ScanSnap.
For details, refer to
Creating Scanned Images Depending on Intended Use (for Windows Users)
"How to Load Documents" (page
"Right-Click Menu (Windows)" (page
63).
222