Chapter 2 - Installing the Devices
Connecting the Cable to the Terminal Block
Note:
The system unit used in the following illustrations may not resemble the actual one.
These illustrations are for reference only.
1. Insert the cable end of the power adapter to the terminal block. To firmly fix the cable into
the terminal block, use a screwdriver to clamp down the wires to the screw that is in the
terminal block
.
Terminal block
Wire
Power adapter cable
Chapter 2 Installing the Devices
Chapter 2
2. Plug the terminal block into the DC-in connector and then tighten the screws to secure the
terminal block in place.
DC-in
connector
+
-
White Wire
Black Wire
10
Screws
www.dfi .com