8-Bit Gpio; I/O Connectors; Lvds Lcd Panel Connector - DFI KS310-IMX6 User Manual

8-bit GPIO

The 8-bit Digital I/O (4-bit input and 4-bit output) connector provides powering-on function to
external devices that are connected to these connectors. The pin functions of the digital I/O
connector are listed below:
Pins Function
DIO_OUT-0
1
DIO_OUT-1
3
DIO_OUT-2
5
DIO_OUT-3
7
DIO_OUT-4
9
DIO_OUT-5
11
+3.3V
13
Chapter 4 Ports and Connectors
Chapter 4
1
13
14 2
1
13
2
14
Pins
Function
2 DIO_IN-0
DIO_IN-1
4
6 DIO_IN-2
8 DIO_IN-3
10 DIO_IN-4
DIO_IN-5
12
14 GND

I/O Connectors

LVDS LCD Panel Connector

The system board allows you to connect a LCD Display Panel by means of the LVDS LCD panel
connector transmitting video signals and power from the system board to the LCD Display
Panel.
Refer to the next page for the pin functions of the connector.
Jumper Settings
Refer to the "Jumper Settings" section in chapter 3 for settings relevant to the LVDS LCD
panel.
Note:
DFI board's LVDS connector: Hirose DF13-40DP-1.25V(91)/40P/1.25mm; cable side
connector: Hirose DF13-40DS-1.25C.
25
40 2
39 1
LVDS LCD Panel
www.dfi .com