Table of Contents
Advertisement
3. Slide the Panel PC through the hole until it is properly fi tted against the panel.
4. Position the mounting clamps along the rear edges of the Panel PC, fi tting them into the slits
that are around the Panel PC.
Mounting
clamp
White plastic
cap
5. The fi rst and second clamps must be positioned and secured diagonally prior to mounting the
rest of the clamps. Tighten the clamp's screw using an electric screwdriver until the white
plastic cap touches the panel. Do not over tighten the screws to prevent damaging the Panel
PC. The illustration below shows all clamps properly mounted.
Chapter 5 Mounting Options
Chapter 5
Slit for mounting
the clamp
Panel wall
Note:
The maximum thickness of your panel's opening should be 10 mm. Be sure to route
or trim down the thick wall to 10 mm or slightly less for the clamps to recess and
be compatible with your wall or enclosure.
34
www.dfi .com
Advertisement
Table of Contents
